<< Click to Display Table of Contents >> Drawing Fault Lines |
To draw a fault line either select Edit > Faults > Draw Fault Line, Popup > Faults > Draw Fault Line or click on the Faults button on the toolbar and select Draw Fault Line. The fault line is represented by a series of line segments. The first line segment should start at a grid boundary or another fault. To draw the fault click on the first point and then click on the points of the remaining line segments. When the last point is reached double-click on it. The last point can be snapped to another fault or a grid boundary. After this the Faults form will be displayed. The use of this form is described in the section below.