Admixtures Tab

<< Click to Display Table of Contents >>

Navigation:  Chapter 9 Geotechnical Data Management > Lookup List Data > Concrete Lists Data > Mix Designs >

Admixtures Tab

Previous pageReturn to chapter overviewNext page

This tab is used to specify the admixtures for the concrete mix design. Admixtures are typically used to reduce costs, achieve required properties, and quality control.

 

 

clip40199

 

At the top of the tab there are buttons to add and remove admixtures. For each admixture the following can be specified:

 

Admixture: This is the name of the admixture.

 

Type: This is the type of admixture. Below is a list of admixture types that can be selected.

Accelerator

Air detrainor

Air-entrainer

Antiwashout

Bonding

Coloring

Corrosion inhibitor

Dampproofing

Foaming agent

Fungicide

Has foamer

Germicide

Grouting

Hydration control

Insecticide

Permeability reducer

Pumping aid

Reactivity inhibitor

Retarder

Shrinkage reducer

Superplasticizer

Superplasticizer and retarder

Water reducer

Water reducer and accelerator

Water reducer and retarder

Water reducer - high range

Water reducer - mid range

Other

 

Dosage: This is used to specify the dosage of the admixture. The dosage is used in determining the proportions of the admixtures.

 

Amount: If the admixture is a water reducer, this is the amount as a percentage that it reduces the required water content.

 

Relative Density: This is the relative density of the admixture.