<< Click to Display Table of Contents >> Navigation:  Chapter 7 Stations and Sampling > Samples > Editing a Sample > Details Tab

The Description tab is used to specify the descriptors, photos, and sampling personnel.

 

 

The following information can be entered on this tab:

 

Descriptors: In addition to the general information and media type data any number of descriptors can be specified and entered for each media type. These descriptors are specified in the list of Descriptors. On this tab the description for each descriptor for the selected media type can be specified.

 

Photos: Sample photos can be added and removed for the sample using the Add and Remove buttons. When a sample photo is added a link to the photo file is shown in the list. When a photo is removed the link is deleted and the photo is not deleted. When a photo is highlighted in the list a preview of the photo will be shown on the right.

 

Sampling Personnel: The sampling personnel can be added and removed using the Add and Remove buttons.

 

 

MEWS Project

 

 

If it is a MEWS data specific project there will be four descriptors:

 

Control Point Code: This is the mandatory 4 digit sample control point code and must match one of the SRDS control points in your MEWS account.

 

Control Point Name: This is the mandatory name of the sample control point (up to 50 characters).

 

Discharge Sample Code: This is the optional sample discharge code (up to 10 characters) used by the discharge for internal documentation.

 

Sample Comment: This is an optional sample comment.