<< Click to Display Table of Contents >> Navigation:  Chapter 3 Scheduling and Tasks > Tasks > Editing a Task > Borings and Wells Task > Borings/Wells Tab

The Borings/Wells tab is used to list and associate all of the borings and wells connected to the task.

 

 

The following information can be specified on his tab:

 

Borings

 

Borings are used to specify the location of current and future borings, The list of borings displays the name, x and y coordinates, depth and date drilled for the boring. The buttons beside the list perform the following functions:

 

Create: This creates a new boring for the task. When pressed the project map will be displayed where the location of the boring can be specified, then the Boring Information form will be displayed. The name, depth, and coordinates for the boring can be entered on this form.

 

Open: This will open the selected boring for editing if it has been created.

 

Link: This will display a list of existing borings from which a boring can be selected to add to the task.

 

Unlink:This will remove the selected boring from the list of borings for the task.

 

 

Wells

 

Wells are used to specify the location of current and future wells, The list of wells displays the name, x and y coordinates, depth and date drilled for the well. The buttons beside the list perform the following functions:

 

Create: This creates a new well for the task. When pressed the project map will be displayed where the location of the well can be specified, then the Well Information form will be displayed. The name, depth, and coordinates for the well can be entered on this form.

 

Open: This will open the selected well for editing if it has been created.

 

Link: This will display a list of existing wells from which a well can be selected to add to the task.

 

Unlink:This will remove the selected well from the list of wells for the task.