Adding a Sample

<< Click to Display Table of Contents >>

Navigation:  Chapter 7 Stations and Sampling > Samples >

Adding a Sample

Previous pageReturn to chapter overviewNext page

There are four methods to add a sample directly in GaeaSynergy.

 

1.Use the Create button on the Stations and Samples tab for a task.

2.Use the Create button on the Sample tab for a station.

3.Select File > New > Sample > Locate on Map or click on the New button on the main toolbar and select Sample > Locate on Map.

4.Select File > New > Sample > Locate Manually or click on the New button on the main toolbar and select Sample > Locate Manually.

 

If the first or third method are used, you will be required to click on the location of the sample on the project map to specify the x and y coordinates.  The second method will assign the sample the same x and u coordinates as the station. In the fourth method these coordinates are entered manually on the Sample Information form. After one of the methods has been used, a Sample Information form will be displayed where the data can be entered as described in the Editing a Sample section below.