<< Click to Display Table of Contents >> Navigation:  Chapter 5 Samples > Editing a Sample > Lab Analyses

The lab analyses that have been conducted on the sample or are to be conducted are specified on this tab.

 

 

The following can be specified on this tab:

 

Cooler ID: This is used to specify the cooler ID for the sample.

 

COC Number: This is used to specify the Chain of Custody number.

 

QC Sequence ID: This is used to specify the quality control sequence ID.

 

QC Sample Type: This is used to select the quality control sample type from the list of QC Sample Types.

 

Extracted: This is used to select whether the sample was extracted.

 

Filtered: This is used to select whether the sample was filtered.

 

Filter: If the sample was filtered, this is used to select the filter from the list of Filters.

 

Filter Size: If the sample was filtered, this is used to specify the filter size and size units.

 

Laboratory: This is used to select the default analysis laboratory from the list of Laboratories. The actual laboratory that conducted the analysis may be different then the default.

 

 

Lab Analyses

 

This is a list of the lab analyses conducted or to be conducted on the sample. If the analysis has not been conducted the date analysed will be blank.

 

Add: Click the Add button to add a new lab analysis to the sample. The Lab Analysis Information form will be displayed and can be edited as described in the section Editing a Lab Analysis.

 

Open: This is used to open the selected lab analysis. The selected lab analysis will be displayed on the Lab Analysis form and can be edited as described in the section Editing a Lab Analysis.

 

Unlink: This will remove the selected lab analysis from the list of lab analyses for the sample. It will not delete the selected lab analysis.