Information Tab

<< Click to Display Table of Contents >>

Navigation:  Chapter 5 Samples > Editing a Sample >

Information Tab

Previous pageReturn to chapter overviewNext page

The Information tab is used to specify the general information for the sample.

 

clip14178

 

The following information can be specified on this tab:

 

Station: If the sample is associated with a station, the station will be shown. This can not be edited.

 

Task: If the sample is associated with a task, the task will be shown. This can not be edited.

 

 

Collected: This should be checked if the sample has been collected.

 

Sample Date: If the sample is not continuous and has been collected, this is used to select the collection date.

 

Start Date: If the sample is continuous and has been collected, this is used to select the start date.

 

End Date: If the sample is continuous and has been collected, this is used to select the end date.

 

Specify Time: If the sample has been collected, this is used to indicate whether the time of collection should be specified.

 

Sample Time: If the time of collection is being specified and the sample is not continuous this is used to select the time.

 

End Time: If the time of collection is being specified and the sample is continuous this is used to select the time.

 

Sample Time: If the time of collection is being specified and the sample is continuous this is used to select the time.

 

 

Sample Uploaded: If the sample has been uploaded from EDMS Field this will be checked. This can not be edited.

 

Date Uploaded: If the sample was uploaded, this displays the date it was uploaded from EDMS Field.

 

 

Sample Type: This is used to select the sample type from the list of Sample Types;

 

Continuous: This is used to select whether the sample is continuous.

 

Required for Permit: Select Yes if this task is required to maintain a permit for he project

 

Purpose: This is used to specify the purpose of the sample.

 

Location: This is used to specify the location of the sample.

 

X Coordinate: This is used to specify the x coordinate of the sample. When the sample is created the x and y coordinates will be filled in by the program.

 

Y Coordinate: This is used to specify the y coordinate of the sample.

 

Elevation: This is used to specify the elevation and elevation units of the sample.

 

Collection Method: This is used to select the collection method from the list of Collection Methods.

 

Methodology: This is used to select the sampling methodology from the list of Methodologies.

 

Variances: This is used to specify any variances from the methodology.

 

Sampling Result: This is used to select the sample result from the list of Sampling Results.

 

Sampling Company: This is used to specify the sampling company.

 

Sources of Environmental Risk: This is used to specify any sources of environmental risk.

 

Weather: This is used to specify the weather at the time of sampling.

 

Field Comments: This is used to specify any field comments.

 

Additional Comments: This is used to specify any additional comments.

 

Number of Composites: This is used to specify the number of composites.

 

 

Associated Boring/Well: If the sample is associated with a boring or well, it can be linked to the sample.