<< Click to Display Table of Contents >> Navigation:  Chapter 3 Projects > Creating a Georeferenced Project > Local Coordinates Tab

If the project is a georeferenced project the map coordinates will be in decimal degrees, for display in 3D local coordinates in either feet or meters will need to be assigned.

 

 

The following information can be specified on this tab:

 

Local Units: Select either feet or meters.

 

Reference Corner: Select the corner of the project to use as a reference. The x and y coordinates below will be assigned to this corner.

 

X Coordinate to Corner: This is the x coordinate of the reference corner.

 

Y Coordinate to Corner: This is the y coordinate of the reference corner.